APM Power Module with XT60 Connectors Kit

The APM Power Module is a simple way of providing your APM with clean power from a LiPo battery as well as current consumption and battery voltage measurements, all through a 6-pos cable. The on-board switching regulator outputs 5.3V and a maximum of 2.25A from up to a 4S LiPo battery. The Power Module comes completely assembled with XT60 connectors, and wrapped in shrink tubing for protection.

OVERVIEW

Note: The Power Module is only designed to power APM, a RC receiver and APM accessories (GPS, 3DR radio). It is not designed to power servos. Use your aircraft's own ESC/BEC for that.

• Max input voltage: 18V
• Min input voltage: 4.5 V
• Max current sensing: 90A with APM, 60A with Pixhawk
• Voltage and current measurement configured for 5V ADC
• Switching regulator outputs 5.3V and 2.25A max
• 6-pos DF13 cable plugs directly to APM 2.5's 'PM' connector

Documentation:

• - Instructions
• - Eagle files
• - Dimensional drawing