Shopping Cart

0 item(s) - RM0.00
Your shopping cart is empty!
MiFare Classic (13.56MHz RFID/NFC) Clear Tag - 1KB

MiFare Classic (13.56MHz RFID/NFC) Clear Tag - 1KB

Product Code:ADA361
Price: RM17.00
  • This is a blank MiFare Classic 'laundry' tag - often used for laundry or identification but also found in other systems where a small proximity card is desired. This one is clear! The tag contains a NXP S50 chip and an antenna, and is passively powered by the reader/writer when placed a couple inches away.

    These can be read by almost any 13.56MHz RFID/NFC reader but make sure it can handle MiFare cards as there are a few other encoding standards (like FeLica) They are tested and work great with both our PN532 NFC/RFID breakout board and Adafruit NFC/RFID Shield for Arduino!

    These chips can be written to & store up to 1 KB of data in writable EEPROM divided into banks, and can handle over 100,000 re-writes. You can use our PN532 NFC/RFID breakout board or Adafruit NFC/RFID Shield for Arduino to read and write data to the EEPROM inside the tag. There is also a permanent 4-byte ID burned into the chip that you can use to identify one tag from another - the ID number cannot be changed.


    S50 chip specification:

    • 1 KiloByte (8 KiloBit) non-volatile EEPROM storage
    • Built in encryption engine with 48-bit key
    • 4 Byte unique identifier burned into the chip
    • 13.56 MHz frequency

    Tag specification:

    • 25.4mm diameter x 1mm / 1" diameter x 0.03"
    • 0.9 grams / 0.03 oz
    • Works about 2" away from reader


    NXP S50 datasheet